Caution: Disconnect power from the control board before beginning any wiring.
If the board you have differs from the one shown in the photo and is powered by 12 or 24V, refer to this diagram:
https://1control.zendesk.com/hc/en-gb/articles/5953763839004
Each existing wire must be left connected and if the SOLO KIT connection uses the same contact as other wires, the new wires must be added to those already present in the same contact.
The scheme is showing the connection to the B channel output, please connect the SOLO KIT receiver to the same output / outputs used by your existing receiver.
This specific control unit model does not have power for external accessories (like the SOLO KIT), so the use of an external power supply will be necessary.
Any power supply with a voltage between 12 and 24V, both AC and DC, can be used, or the following:
https://www.1control.eu/ecommerce/en/1control-solo-kit-power-supply.php
