To complete the copy of your remote control
- Start copying until you get to the "Verify Operation" screen
- Press the menu button on the top right to enter manual recording as in the image below
- Move both sliders shown to 4 seconds
- Locate the 3 buttons used for menu navigation: "+", "-" and "OK"
- Press the "OK" button, if "Param" does not appear on the display, press "OK" again
- Use the "+" and "-" buttons to get to the "Radio" item and press "OK"
- Use the "+" and "-" buttons to get to the "Add start" item and press "OK"
- The message "Hidden button" will appear on the control unit, in the 1Control app press the "Transmit source code" button and wait 5 seconds
- When the message "Key desired" appears on the control unit, press the "Transmit opening signal" button on the app and wait 5 seconds
- The display should show "OK" followed by a number
- Wait approximately one minute for the control unit to exit programming mode.
- Press the "Next" button at the bottom of the app
- Test the storage operation using the "Open/Close" button