ZA3P

To complete the copy, follow the procedure as indicated

1. Start copying until the "Check operation" screen
2. Press the menu button at the top right to enter manual recording as in the image below
3. Move the slider higher than 5 seconds
   
   
   
   
4. On the control unit, press and hold the " CH1 " button, the " PROG. " LED starts to flash
   
   
   
   
5. On the application, press the " Send opening signal " button and wait about 5 seconds
6. The LED lights up steadily to indicate code storage
7. Release the " CH1 " button

If the LED does not light up steadily, release the " CH1 " button, wait 5 seconds and repeat from point 4