1) Start copying until you get to the "Check Operation" screen
2) Press the menu button at the top right to enter manual recording as shown in the image below
3) Move the slider above 5 seconds
2) Press the menu button at the top right to enter manual recording as shown in the image below
3) Move the slider above 5 seconds
4) Press and hold the " P1 " button on the control unit, it should emit a short beep followed by a long one
5) Keeping the device SOLO near the control unit, press the " Transmit opening signal " button in the app and wait 10 seconds
6) Release the " P1 " button on the control unit
In the 1Control app, press the "Next" button at the bottom and perform an opening test. If this is not successful, increase the transmission time set in step 3 and the wait during step 5.