If it is necessary to restore the SOLO AUTO device to factory settings (for example, to delete all data, in case of a lost PIN, or to perform a configuration from scratch), a reset can be performed using the physical button on the device.
WARNING!
This operation involves the permanent deletion of all stored remote controls and set PIN codes. Once the reset is complete, the device will return to its initial state and a new configuration via the App will be required. Below is the step-by-step procedure:
Locate the button on the external casing of the SOLO AUTO.
Press and hold the button for about 10 seconds.
Check the LED light sequence:
Initially, the LED will flash 3 times quickly.
Subsequently, it will start flashing rhythmically (one flash every half second).
Wait for the LED to completely stop flashing.
When the light goes out permanently, the Reset is successfully finished.