To complete the copy, follow the procedure as indicated
- Start copying until the "Check operation" screen
- Press the menu button at the top right to enter manual recording as in the image below
- Move the slider higher than 4 seconds
- DIP SWITCH 3 (indicated in green in the image) must be moved to the ON position, therefore towards the right side of the board
- Press the PROG button on the control unit (indicated in red in the image) until the buzzer starts ringing and the LED is on, then release the button, the LED must remain on
- On the app, press the Transmit opening signal button and wait 10 seconds
- Press Transmit opening signal again and if the gate is operated correctly, move DIP SWITCH 3 towards the OFF position