GEN1
Copy the remote control on 1Control SOLO and stop at the screen where the app says it must communicate with the gate receiver
In the upper right hand gate receiver there are 3 buttons ( +, OK, - ).
Go to the radio item and press PG, then select the “ PP ” function. This function enables the registration of a new remote control.
On the app press "I am near the gate"
GEN2
To complete the copy of your remote control
1) Start copying until the "Operation Check" screen
2) Press the menu key at the top right to enter manual recording as shown below
3) Move the slider above 10 seconds 
4) In the upper right hand gate receiver there are 3 buttons ( +, OK, - ).
Go to the radio item and press OK, then select the “ PP ” function. This function enables the registration of a new remote control.
5) On the app, press the "Send opening signal" button