To complete the copy follow the procedure as indicated
- Start copying until you get to the "Verify Operation" screen
- Press the menu button on the top right to enter manual recording as in the image below
- Move the upper slider to 4 seconds and the lower slider to 5 seconds.
- On the control unit press the OK button and the display will show the word PARAM
- Press the " - " button until the RADIO item appears
- Press OK
- AGG.Start will be displayed, press OK again
- When the message " hidden button " appears on the display, press the " Transmit source code " button in the app.
- The display will show " Release ", wait for the signal processing to finish
- When the message " desired key " appears on the LCD, press the "Transmit opening signal " button in the app
- The control unit display should read " OK " followed by a number.
- in the app press the " Next " button, located at the bottom, and perform an opening test by pressing the " OPEN/CLOSE " button
- If the test is successful, press " Ok, done " at the bottom, otherwise you need to follow the procedure again.