GEN1
Start copying until you reach the Check Operation screen
On the receiver, press the SW1 key once.
The LED should blink
On the remote control, press the hidden button (using the hidden button on the back or by pressing the two upper buttons at the same time)
The LED stays on steady
On the app, press the OPEN / CLOSE button on the app
GEN2
To complete the copy, follow the procedure as indicated
- Start copying until the "Check Operation" screen
- Press the menu button at the top right to enter manual recording as shown in the image below
- Move the slider above 4 seconds
- On the receiver press the SW1 button once, the LED should flash
- On the original remote control, press the hidden button (using the hidden button on the back or by pressing the two upper buttons at the same time) The LED remains on steady
- On the app, press the Transmit opening signal button