GEN1
- Copy the remote control on 1Control SOLO and stop at the screen where the app says it must communicate with the gate receiver
- In the upper right hand gate receiver there are 3 buttons (+, PG, -).
Go to the radio item and press PG, then select the “PP” function. This function enables the registration of a new remote control.
- On the app, press "I am near the gate"
GEN2
To complete the copy of your remote control
1) Start copying until the "Operation Check" screen
2) Press the menu key at the top right to enter manual recording as shown below
3) Move the upper slider to 4 seconds
4) In the gate receiver at the top right there are 3 buttons (+, PG, -).
Go to the radio item and press PG, then select the “PP” function. This function enables the registration of a new remote control.
5) On the app, press the "Send opening signal" button