The control unit is located in a junction board that is located near the basculant door that manages:
To complete the copy of your remote control
1) Start copying until you get to the "Check Operation" screen
2) Press the menu button at the top right to enter manual recording as shown in the image below
3) Move both sliders to 4 seconds (both the one for the opening signal and the source code)
4) Access the control unit board and locate the 3 buttons next to the LCD screen
5) Press the OK button twice and then press the - button until the word Radio appears
6) Press OK and when Agg1ch appears press OK again
7) On the LCD screen you should see hidden button written
8) Press the " Transmit source code " button on the app, wait
9) On the LCD screen you should see release written, followed by the desired key
10) Press the " Transmit opening signal " button on the app
11) Wait for the procedure to finish, the screen on the control unit should show "OK
Press "Next" in the app and test open with the "Open/Close" button
If the basculant does not operate, repeat the procedure again, otherwise continue with the instructions on the app.