To complete the copy, follow the procedure as indicated
- Start copying until the "Check Operation" screen
- Press the menu button at the top right to enter manual recording as shown in the image below
- Move the slider above 4 seconds
- On the receiver, press the PROG programming button on the receiver for 1 sec, you will hear an acoustic signal. The receiver will enter the programming of the first relay.
- NB If the key is pressed, the programming passes to the second relay, and then cyclically passes from one relay to the other every second as long as the PROG key remains pressed
- Press the Transmit opening signal button on the app, the receiver beeps for 0.5 sec
Wait 10 seconds to exit programming mode, the receiver will exit programming mode by emitting two 1-second beeps
Attention:
If when programming a transmitter, the receiver's memory is full, it will emit 7 acoustic signals of 0.5 sec and exit programming.
RADIOBAND
The RADIOBAND / RU allows you to record 6 RADIOBAND / TA and / or RADIOBAND / TBX (3 for Relay 1 and 3 for Relay 2)
Press the PROG programming button on the receiver for 1 sec, you will hear an acoustic signal. The receiver
will enter the programming of the first relay. If you keep the programming button pressed, the receiver
will enter the programming of the second relay, passing from one relay to the other in a cyclical manner. After choosing the
programming relay for the transmitter to be activated, send the code to be programmed by pressing
the issuer. Each time a transmitter is programmed, the receiver beeps for 0.5 sec. Self
after 10 seconds the programming has not been completed, the receiver will exit the programming mode by emitting two acoustic signals of 1 sec. If when programming a station, the receiver's memory is full, this one
it will emit 7 acoustic signals of 0.5 sec and exit programming.