Procedure for SLH radio controls
To complete the copy, follow the procedure as indicated
- Start copying until the "Check operation" screen
- Press the menu button at the top right to enter manual recording as in the image below
- Move the slider higher than 4 seconds
- On the control unit, press and hold the SW3-LOGIC button (highlighted in red) and while keeping it pressed, also press SW1-SETUP (highlighted in green) until the LED starts to flash slowly, when the LED flashes, release both.
- Within 5 seconds, press the Transmit opening signal button on the app.
- The LED will remain lit for approximately 1 second indicating that the procedure was successful.
- On the app, press the Transmit opening signal button to check if SOLO can open the gate.
If it opens successfully, press "Ok, I'm done" at the bottom and finish the wizard
If not, try again from point 4 of the guide