To complete the copy of a DS radio control , follow the procedure as indicated
- Start copying until the "Check Operation" screen
- Press the menu key at the top right to enter manual recording as shown in the image below
- Move the slider above 4 seconds
- On the receiver, press the SW1 button (or SW2 depending on the connected output) for about one second until the LED adjacent to the button starts flashing slowly
- At this point, press the Transmit opening signal button on the app
To complete the copy of an SLH remote control , follow the procedure as indicated- Start copying until the "Check Operation" screen
- Press the menu key at the top right to enter manual recording as shown in the image below
- Move the slider above 4 seconds
- Press the "Send source code" button in the app (the second from the top, in blue)
Then on the receiver the SW1 button - The led corresponding to the channel used on the receiver starts flashing slowly for 5 sec.
- Within 5 seconds, press the "Transmit opening signal" button in the app (the first at the top, in blue)
) The led on the board) will light up steadily for 1 second and then go off, indicating that memorisation has been completed.
To complete the copy of an LC radio control , follow the procedure as indicated
- Start copying until the "Check Operation" screen
- Press the menu key at the top right to enter manual recording as shown in the image below
- Move the slider above 4 seconds
- On the receiver, press the SW1 button (or SW2 depending on the connected output) for about one second until the LED adjacent to the button starts flashing slowly
- Within 5 seconds, press the "Transmit opening signal" button in the app
- The LED on the receiver will light up steadily for 1 second, indicating that memorisation has been completed